Also clean up some log messages.

This is done to provide better data to our right-censored Pareto model.

We do this by simply marking them with a new purpose.

Histogram conversion causes accuracy loss, and there are some
boundary conditions when we hit 1000 circuits that cause
false negative test results.

Check for overflow in one place, and be consistent about type usage.

There are now four ways that CBT can be disabled:

1. Network-wide, with the cbtdisabled consensus param.
2. Via config, with "LearnCircuitBuildTimeout 0"
3. Via config, with "AuthoritativeDirectory 1"
4. Via a state file write failure.

This prevents a spurious warning where we have a timeout just after
deciding our network came back online.

This should prevent some asserts and storage of incorrect build times
for the cases where Tor is suspended during a circuit construction, or
just after completing a circuit. The idea is that if the circuit
build time is much greater than we would have cut it off at, we probably
had a suspend event along this codepath, and we should discard the
value.

In case we decide that the timeout rate is now too high due to our
change of the max synthetic quantile value, this consensus parameter
will allow us to restore it to the previous value.

This is for the other issue we saw in Bug 1335. A large number of high
timeouts were causing the timeout calculation to slowly drift upwards,
especially in conditions of load. This fix repeatedly regenerates all of
our synthetic timeouts whenever the timeout changes, to try to prevent
drift.

It also lowers the timeout cap to help for some cases of Bug 1245, where
some timeout values were so large that we ended up allocating a ton of
scratch memory to count the histogram bins.

The downside is that lowering this cap is affecting our timeout rate.
Unfortunately, the buildtimeout quantile is now higher than the actual
completion rate by what appears to be about 7-10%, which probably
represents the skew in the distribution due to lowering this synthetic
cap.

In my state files, I was seeing several peaks, probably due to different
guards having different latency. This change is meant to better capture
this behavior and generate more reasonable timeouts when it happens. It
is improving the timeout values for my collection of state files.

The main changes are to explain how we use git branches, how we use
changes files, and what should go into a patch.  Putting these in
HACKING means that we shouldn't need to constantly refer to the or-dev
emails where we explain this stuff.